Chapter 6: IP interface configuration
Note:
To program DHCP addressing, you must complete certain sequences within a
Note:
predetermined time-out interval. Avaya recommends that you read the following
procedure completely before you start so that you are familiar with these
sequences in advance.
Perform one of the following tasks depending on whether you use static or dynamic addressing:
Programming the IPSI for static addressing
Programming the IPSI for DHCP addressing
Programming the IPSI for static addressing
!
Important:
If an IPSI is in a port network that is backed up with the Enterprise Survivable
Important:
Server (ESS) option you must use static addressing for the ESS to provide
service to the port network.
You administer the static IP address for the circuit pack directly through the Ethernet port
connection on the faceplate (top port). See
58
Installing and Configuring the Avaya S8700-Series Server
on page 58
on page 62
Figure
5.
January 2008