Manually Setting The Motor Cal Value For A Variable Rate System - CONCORD 2800 Operator's Manual

3.11.5 Manually setting the motor cal value for a variable rate system

Procedure
Select
(1) for the desired bin:
1.
2. Select the Calibration Weight (2).
Enter the desired calibration weight (2).
3.
The calibration weight is the amount of product
applied per revolution on the meter roller. The
calibration weight is calculated using the
accumulated weight value (2) and the
revolutions of the meter. If the motor spins 10
revolutions and accumulates 10 pounds, the
calibration weight value is 1.000.
Do not Change the Product Density After
Calibrating - The calibration number will
change.
3. Operation
75