Using The Auger To Unload Products; Cleaning Out The Auger - CONCORD 2800 Operator's Manual

3.3.2 Using the auger to unload products

Procedure
Swing the inner arm far enough away from the machine to let the hopper fit in front of the wheels.
1.
See the information for inner arm position.
Put the hopper (1) under the meter for the
2.
desired compartment.
For rear tank on three-bin models, the outer
arm will have to swing more than 180
degrees to reach the meter.
Close the metering slide (2).
3.
Remove the product meter door (3).
4.
Open the metering slide to control flow from
5.
the compartment.
Removing the pointer lets the gate open
without changing the rate setting.

3.3.3 Cleaning out the auger

Procedure
Park the machine on a solid, level surface.
1.
Apply the park brake, stop the engine, and take the key with you.
2.
If desired, put a catch pan under the auger.
3.
Put the hopper (1) upside down to empty.
4.
If desired, put a catch pan under the auger.
5.
Run the auger rearward until the auger tube
6.
is empty.
Fig. 7
Fig. 8
3. Operation
54