Table of Contents
Advertisement
3.15.3 Master switch operation
The cart control system requires a master work switch.
The master work switch is an icon
automatic work switch is a sensor, located on toolbar.
When the system is configured for automatic work switch operation, lifting the machine automatically turns
off the meters and NH3 system. Lowering the machine automatically turns on the meters and NH3 system.
In this mode the manual work switch can be used on the terminal to turn the meters and NH3 system off.
Disable the automatic height switch if desired configure the system to operate the meters and NH3 system
in manual only.
3.15.4 Enabling Automatic Height Switch
Procedure
1. From the main (home) work screen, select
2. Select the box on the bottom of the screen to enable the Height Switch.
3. Return to Home and there will be an arrow next to the master icon to symbolize
the state of the implement.
3.15.5 Manual work switch operation
To change the state of the master switch, use the foot switch that is supplied with the cart. This should be
placed in the cab within reach of the operator.
3.15.6 Setting the automatic height switch operation
Procedure
1.
Raise the seeding system.
2.
Depress the foot-pedal to change the state of the master switch
3.
Move the machine forward in the field.
4.
Lower the seeding system.
The following conditions must be met for the clutch to engage or for the hydraulic motors to turn:
The ground speed must be above the minimum speed setting.
•
The master switch icon must be green.
•
The Seeder up/down will indicate down and green
•
3.15.7 Customizing Product Tabs
1. Select Settings:
2. Select System Settings tab:
3. Select Display Setup Menu:
4. Each Product is con gurable to display what you wish.
There are select tabs that are not editable that are required to be displayed
to Select" readouts are editable and can display a variety of outputs
Note: "RPM 1" is the fan speed output
280/335/380/525 Bushel Air Carts
331815
located on the lower portion of most screens on the terminal. The
to change
the work switch operation mode.
3. Operation
All "Press
114
Advertisement
Table of Contents
Troubleshooting
