Taking A Product Sample For Calibration - CONCORD 2800 Operator's Manual

3. Operation
6. Catch Test Summary;
a. Select Edit
b. Enter a Test Speed
i. Highlight the field and press
"ok" to enter a value.
ii. Approximately the speed at
which you will be seeding.
c. Enter Rate at which you will be
applying that product.
i. Highlight the field and press
"ok" to enter value.
d. Enter Desired weight to be
dispense
i. Highlight the field and press
"ok" to enter a value.
ii. Recommended to catch
15-25 lbs of product.
iii. No less than 10lbs.
7. Select Next.
8. Select Prime;
a. The Meter will turn 1 revolution
b. It is suggested to Prime (1) 2-3 times
to ensure the meter is full of
product.
9. Empty Calibration hang back under the
desired meter and begin Calibration.

3.11.3 Taking a product sample for calibration

1. Hang Calibration bag under meter being
calibrated
2. Press Start (1).
3. When Calibration is complete you will be
prompted to enter Actual Amount Applied;
a. Use arrow pad to enter value
measured using scale provided in
the calibration kit.
b. When measuring, be sure to have
zeroed the scale with the bag
weight in account.
c. Be sure the scale is in "lbs".
Fig. 28
Fig. 29
Fig. 30
Fig. 31
71