Table of Contents
Advertisement
Authorised staff only
7.1 SET-UP (
Set-up
During first st art -up, t he funct ions/ paramet ers list ed below m ust be set or adjust ed:
Dishwasher parameter modification procedure
W ith the tank empty
1- Sw it ch t he appliance on; t he display w ill show " FILL" and
filling w ill st art .
2- Open t he door/ lift t he hood (depending on t he model);
" CLOSE" w ill appear on t he display
3- Press t he
but t on and hold it dow n for 5/ 7 seconds.
When -------- appears on t he display, release t he but t on and
press it again t o access t he main PCB set up menu.
W ith the tank full/ the hood open
1 - Press t he
but t on and hold it dow n for 5/ 7 seconds.
When -------- appears on t he display, release t he
and press it again t o access t he main PCB set up m enu.
All the modifiable parameters can now be displayed, scrolling through them with the
Press the
button to select the value required for each parameter.
To confirm the value required simply quit the menu or move on to the next parameter by pressing
.
Quitting the setup menu automatically: wait about 3 minutes without using the controls.
Quitting the setup menu in manual mode: hold the ON/OFF button until the beep sounds; the
dishwasher switches off.
7.2 M odifiable parameters
The illustrations are purely guideline. The minimum and maximum temperatures available depend on the
model (glass washer, dishwasher, undercounter or hood-type model, ..).
Rinsing temperature
(boiler temperature)
W arning:
The t ank and boiler t emperat ures show n on t he display may be different from t he act ual
t emperat ures by a few degrees, especially in t ransient phases (just aft er t he FILL is complet ed, just aft er
t he end of t he cycle, et c.) due t o t he inert ia of t he measurement probe.
)
but t on
19
W ashing temperature
(tank temperature)
button.
Advertisement
Table of Contents
