Smeg SHR+ Translation Of The Original Instructions page 36

13 TROUBLESHOOTING
PROBLEM
THE INDICATOR LIGHT L1 DOES NOT
LIGHT UP
THE WASHING PROGRAM DOES NOT
START
POOR WASHING RESULTS
INSUFFICIENT RINSE
INSUFFICIENT DRYING
STAINED GLASSES AND CUTLERY
POSSIBLE CAUSE
line volt age failure
The dishw asher filling is not over yet.
CLOSE st ays on display
Clogged or crust ed spray arm s holes.
Clogged filt er
Insufficient or im proper det ergent or
rinse aid.
Failing or insufficient use of
det ergent or rinse aid: t he det ergent
or rinse aid cannot be wit hdraw n
from t he dedicat ed cont ainers.
Badly posit ioned dishes / glasses.
Low w ashing t emperat ure
Im proper set cycle
Clogged nozzles
Boiler incrust ed w it h lim escale
Inappropriat e rinse aid, or it is not
dispensed correctly.
Low rinsing t em perat ure
Inappropriat e rinse aid, or it is not
dispensed correctly.
Wat er hardness superior t han 12°dF
or it cont ains m any dissolved salt s.
Wast e t ube badly positioned or
part ially clogged.
35
POSSIBLE SOLUTION
Verify elect ricit y connect ion.
Wait for FILL t o disappear off t he display
If CLOSE st ays even w it h t he hood closed,
cont act t he Aft er-Sales Service.
Dism ount and clean t he spray arm s
(10.2 Periodical checks)
Read " cleaning t he filt ers during t he day"
Verify det ergent t ype and quant it y.
Worn or broken internal tube for
det ergent or rinse aid of t he perist alt ic
pum p, t o be replaced by the Aft er-Sales
Service.
This ordinary maintenance service is
recommended at least once a year for
the correct functioning of the dosers.
Place dishes / glasses correct ly.
Verify t he t emperat ure displayed,
if it is inferior t han 50°C cont act
cust omer Support .
Increase the duration of t he w ashing
cycle, especially if t he load is very dirt y or
part ially dried.
- Verify that t he nozzles are clean and t hat
t he w ater soft ener, if present , is working
correctly.
- Verify that t he filter of t he t ube placed
inside t he rinse aid jerrycan is not
clogged.
Verify t he rinse aid cont ainer and if it is
adequat e t o t he t ype of m ains w ater.
Verify t he boiler set t em perat ure
Rest ore T St op ON and/ or connect t he
m achine t o hot w ater.
If the problem is not solved, cont act t he
Aft er-Sales Service.
Verify t he rinse aid cont ainer and if it is
adequat e t o t he t ype of m ains w ater. If
t he problem is not solved, cont act t he
Aft er-Sales Service
Verify t hat the tube and drainage are not
clogged and that t he drainage is not