Regeneration frequency setup (models w ith softener)
(Default value: H03 ; m odify t he paramet er t o suit t he mains w at er hardness.
At first use, t he salt t ank has t o be filled. It is subsequent ly sufficient simply t o fill up w it h
regenerat ing salt w hen necessary.
Important:
During normal operat ion, t he dishw asher w ill perform a
number of w ashing cycles w hile regenerat ion is in
progress. During t his t ime (5-6 cycles) t he int ake w at er
w ill not be t reat ed, but t his w ill not affect t he w ashing
qualit y.
Wit h values over 60°f an ext ernal w at er t reat ment device must be used and t he regenerat ion frequency
must be set on H00 .
Extra rinse
"Clean water" cycle
Ppm-
mg/ l
150
200
300
400
500
600
Rinsing is 10" longer t han t he st andard in each w ashing
On: enabled – OFF: disabled .
Wit h t his opt ion clean w at er is used for every washing . At
each cycle, t he w ashing w at er is complet ely drained and it is
replaced w it h clean w at er from rinsing.
On: enabled – OFF: disabled .
N.B.: prolonged use of t his opt ion leads t o higher det ergent
and rinse aid consumpt ion.
21
Hardness
Hardness
(°dH
(°dF
German
French
degrees)
degrees)
Regenerat ion off
8,5
15
11
20
17
30
22,5
40
28
50
33,5
60
cycle.
Setting level
H00
H01
H02
H03
H04
H05
H06