Table of Contents
Advertisement
12.3 Topping up with regenerating salt (for models with softener)
W arning: use specific salt only, do not use cooking sea salt .
The salt cont ainer has a capacit y of about 1 kg of granulated salt .
Correct procedure to refill the regenerating salt:
- st art a tank pump-out ,
- refill the regenerat ing salt ,
- fill t he t ank (FILL)
- rest art t he tank pump-out
- remove any salt residues from t he bot t om of t he t ank, as it may cause
corrosion/ rust .
This procedure prevents t he w ashing w at er t o ent er t he salt cont ainer
(possible damage t o t he decalcifier) and t hat possible residues of salt are
left in t he t ank (risk of corrosion/ rust ).
12.4 Routine inspection of the spray arm (once a week )
Remove t he w ashing and rinsing (t op and bot t om) spray arms by unscrew ing t he cent ral screw ; rem ove the
rinsing spray arms 3 and remove t he screw s 2 as show n. Do not unscrew the nozzles. Clean t he holes and
nozzles under a jet of clean running w at er ; do not use tools which might cause damage. Reassemble t he
spray arms w it h care.
Clean t he out side of t he appliance w it h a damp clot h and neut ral soap, rinsing and drying t horoughly.
12.5 Lengthy periods out of use
If t he dishw asher is t o be out of use for a fairly long period of t ime, the detergent and rinse aid dispenser
devices must be emptied to prevent crystallisation and damage to the pumps: remove t he int ake hoses
from t he det ergent and rinse aid cont ainers and place t hem in a cont ainer of clean w at er, t hen perform a
few w ash cycles follow ed by a complet e pump-out . Finally, t urn off t he mast er sw it ch, close t he w at er
int ake valve and leave t he hood ajar unt il t he int erior is complet ely dry. The det ergent and rinse aid int ake
hoses must be put back int o t he cont ainers w hen t he dishw asher is ret urned t o service, taking care not to
swap them over (red hose = det ergent , blue hose = rinse aid).
34
Advertisement
Table of Contents
