Smeg SHR+ Translation Of The Original Instructions page 23

Thermostop
If t he t hermost op device is set " off" t he rinsing ° t are no longer monit ored and t he user is
responsible for ensuring t hat t he minimum correct ° t are maint ained for t he t ank and boiler. It is
part icularly im port ant
Also refer t o t he insufficient w ashing/ drying / foam in t ank point of t he " t roubleshoot ing" sect ion :
rest ore ° t St op ON and/ or connect t he appliance t o a hot w at er supply.
High speed (FST) or economy (ECO) filling (FILL)
Cycles performed counter
USER program duration customisation (optional, only if installed)
Set as " on" = minimum rinsing temperature as set , (see
boiler t emperat ure above) regardless of int ake w at er
t emperat ure; t he cycle durat ion may be a few seconds
longer t han t he nominal lengt h.
Set as " off" = t he minimum rinsing temperature might be a
few degrees low er t han t he set t ing if hot int ake w at er is not
used.
t o check t he
Fast start (FST): st art s t he dishw asher in less t han t he
st andard t ime; leads t o higher w at er consumpt ion for t he
Eco start (ECO): st art s t he dishw asher in st andard t ime, w it h
Show s t he count of t he t ot al cycles performed by t he
dishw asher since inst allat ion.
This parameter cannot be modified or reset unless t he
USER. 03.10 is t he only program w hich can be cust omised.
Scroll t hrough t he set up paramet ers t o display USER.P1,
P2..... follow ed by t w o dashes (e.g. P2-- ). Keep pressing t he P
but t on unt il USER appears follow ed by t he durat ion
(e.g. USER. 03.10 ).
22
int ake w at er
first cycle st art .
no added w at er consumpt ion.
On: enabled – OFF: disabled.
soft w are is reprogrammed.
t emperat ure.