Toro Groundsmaster 5900 Series Service Manual page 516

Disassembly (Figure
Assembly (Figure 356)
Operator Cab : Service and Repairs
356) (continued)
3. If necessary, remove wiper arm assembly:
A. Disconnect washer hose from wiper assembly.
B. Lift caps at top of wiper arms and remove flange nuts that secure wiper
arms to wiper motor.
C. Use suitable puller to remove tapered wiper arm sockets from wiper
motor shafts.
4. If access to wiper motor is necessary, remove roof panel from top of cab to
allow access to wiper motor assembly (see
Remove wiper motor components using
1. If required, install removed wiper motor components using
a guide.
A. If wiper bracket (item 8) was removed, apply bead of RTV sealant around
wiper opening on inside of headliner before installing bracket.
B. If jam nut (item 16) was removed, torque jam nut to 11.3 N·m (100 in−lb)
during assembly.
C. Make sure that wiper motor electrical connector is secured to cab wire
harness.
D. Secure roof panel to top of cab (see
2. If wiper blade was removed, apply medium strength thread locker to threads
of cap screws (item 2). Secure blade to wiper arm assembly with two (2)
cap screws and lock washers.
3. If wiper arm assembly was removed:
A. Clean tapered wiper arm sockets and wiper motor shafts.
B. Run the wiper motor for one (1) cycle to allow the motor to return to the
normal OFF position.
g299961
Figure 356
Roof Assembly (page
Figure 357
Page 9–30
Roof Assembly (page
as a guide.
Figure 356
9–9)).
Groundsmaster ®
16227SL Rev B
9–9)).
as
5900 & 5910