Front Cutting Deck Winglet Assembly
Cutting Decks: Service and Repairs
(Figure
B. If new eccentric spacers are being used, initially orient the eccentric
spacers with the eccentric lobe downward (notch across hex point
upward −
Figure
deck (see machine Operator's Manual).
5. Tighten cap screws and lock nuts securing eccentric spacers from 56 to 75
N·m (41 to 55 ft−lb).
6. Check front cutting deck pitch and adjust as needed (see machine Operator's
Manual).
7. Lubricate hinge pin grease fittings.
8. Install and secure all removed covers to front cutting deck.
324) (continued)
326). Level the front winglet deck to the front center
Page 8–8
Groundsmaster
®
5900 & 5910
16227SL Rev B