Toro Groundsmaster 5900 Series Service Manual page 469

Front Cutting Deck Winglet Assembly
Groundsmaster ® 5900 & 5910
16227SL Rev B
(Figure
1. Position winglet to front deck.
Note: Install previously used eccentric spacers in their original locations.
2. Install eccentric spacers in winglet and center frame brackets. Secure front
deck winglet to center deck with hinge pins, cap screws and lock nuts. Do
not fully tighten fasteners.
3. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension and
install upper (winglet) drive belt. Make sure that idler pulley applies tension
against the back side of the belt.
g299361
1. Eccentric
2. Deck bracket
g299362
1. Eccentric spacer
4. Set the eccentric spacers:
A. If previously removed eccentric spacers are being used, align the marker
or paint pen lines made during disassembly to position the eccentric
spacers (Figure
324)
Figure 325
3. Marker/paint line
4. Eccentric access hole
Figure 326
2. Notch across hex point
325).
Page 8–7 Cutting Decks: Service and Repairs