Toro Groundsmaster 5900 Series Service Manual page 455

Operator Seat Installation
Groundsmaster ® 5900 & 5910
16227SL Rev B
(Figure 316)
g299267
1. Seat
2. Suspension assembly
1. Carefully position seat to seat suspension.
2. Secure seat to seat suspension with four (4) Torx head screws
Make sure that longer screw is positioned near the seat adjustment handle.
Tighten screws from 25 N·m (18 ft−lb).
3. Position and secure console arm assembly to seat. Install all fasteners
before fully tightening them.
A. Secure support bracket at front right corner of seat to support channel
with flange nut and carriage screw (item 10).
B. Secure console support to coupling nut with cap screw (item 1) and lock
washer.
C. Place flat washer, seat belt receptacle (item 6) and spacer between seat
and console and secure with flat washer and cap screw (item 3). Tighten
cap screw from 68 to 81 N·m (50 to 60 ft−lb).
D. Fully tighten all fasteners to secure console support to seat assembly.
4. Connect seat electrical connector to machine wire harness.
Figure 317
3. Torx head screw − 12mm (3)
4. Torx head screw − 16mm
Page 7–41
(Figure 317).
Chassis: Service and Repairs