Toro Groundsmaster 5900 Series Service Manual page 418

Wheel Removal (Figure
Wheel Installation (Figure
Chassis: Service and Repairs
289) (continued)
Make sure machine is parked on a solid level surface such as a
concrete floor prior to raising machine. Use appropriate hoists and
jacks to raise the machine. Chock or block wheels to prevent the
machine from shifting. Use appropriate jack stands to support the
machine. If the machine is not properly supported by jack stands,
the machine may move or fall, which may result in personal injury.
4. Using a jack, raise machine so wheel to be removed is off ground (see
Jacking Instructions (page
stands.
5. Remove lug nuts and then remove wheel from machine.
289)
Note: The front wheels use six (6) lug nuts. The rear wheels use five (5) lug nuts.
1. Install wheel and secure with lug nuts.
2. Lower machine to ground.
Failure to maintain proper wheel lug nut torque could result in failure
or loss of wheel and may result in personal injury.
3. Torque wheel lug nuts evenly in a crossing pattern from 124 to 145 N·m
(92 to 108 ft−lb).
CAUTION
1–6)). Support machine with appropriate jack
WARNING
Page 7–4 Groundsmaster ® 5900 & 5910
16227SL Rev B