Input Module Replacement; About; Procedure - Precor GEN06 Series Service Manual

Input Module Replacement

About

This procedure provides instruction to remove and replace the

Procedure

Review entire procedure before starting.
1. Set the treadmill circuit breaker to OFF and
AC outlet.
2. Remove the treadmill's hood.
3. Remove the two screws that fasten the AC input panel to the frame. Keep fasteners for
replacement installation.
4. Incline the AC input panel from the frame and rotate it to expose the AC line cord clamp
screws and input module screws
5. .Remove the mounting screws and remove the AC power cord clamp. Keep fasteners
for replacement installation
6. Disconnect the AC line cord from the input module.
1
Alternating Current: electric current which periodically reverses direction between positive
and negative polarity.
2
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Input Module Replacement
1
AC Input Module.
2
unplug the treadmill's power cord from the
Page 73