Precor GEN06 Series Service Manual page 90

17. Align the bottom plate and pivot bracket holes with the running deck bolt holes. Replace
the roller guard, install and hand tighten the deck mounting bolts.
18. Verify that the spacing on all four corners is the same, adjust as necessary.
19. Check the alignment of the magnet and the auto stop assembly, see
Replacement" on page
20. Tighten and torque the Deck mounting bolts to 150 in-lbs (17 N-m).
21. Reinstall the Drive Roller and Drive Belt, see
22. Reinstall the Take-Up roller, see
23. Tension and verify the running belt tracking, see
Adjustment" on page
24. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take-Up roller shaft, see
25. Replace the end cap, see
New Deck break-in
26. Straddle the running belt and set the speed to 3 mph (5 kph). While holding the treadmill
handles, walk onto the middle of the running belt starting from the back walking to the
front and returning to the back. Repeat walking process 4 times.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
51.
"Take-Up roller Replacement" on page
45.
"End Cap & Belt Guard Cover Replacement" on page
"End Cap & Belt Guard Cover Replacement" on page
6 Replacement Procedures
Running Belt and Deck Replacement
"Drive Roller Replacement" on page
"Running Belt Tension and Tracking
"Auto Stop Sensor
62.
86.
66.
66.
Page 83