Precor GEN06 Series Service Manual page 28

DIAGNOSTIC TEST
KEYBOARD TEST
1
PVS KEY TEST
HEART RATE
ACTIVE STATUS
(1)
LIGHT
AS LIGHT
(1)
BRIGHTNESS
3
MC LIGHT
BELT SPEED TEST
AUTO STOP TEST
INCLINE TEST
1
Personal Viewing System display.
2
Active Status Light: Service and maintenance status light.
3
Motor controller or motor controller module
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
An illuminated LED map of the function keys will be shown. Press
each individual key and verify that the corresponding LED extin-
guishes. Press and hold BACK to exit the test.
Not used, OEM test.
Tests the unfiltered, filtered, and pulse heart rate. Grasp the grips
to test the hand held heart rate. Use a Polar heart rate simulator to
test the wireless heart rate. Press the BACK button to exit this
test.
2
The current ASL status light state (blue. pulsing blue, yellow, &
pulsing yellow).
Sets the ASL light brightness level and ON/OFF state: HIGH.
MED, LOW, and ON/OFF.
Shows current state of MC LED-Hold Quick Start to reset.
menu: MACHINE TEST > BELT SPEED TEST
Tests belt operating condition in 0.1 speed increments
Test parameters:
• AMPS IN: Treadmill input Current.
• VOLTS IN: Treadmill input Voltage
• VBUSS: Treadmill internal buss Voltage
• AMPS MTR: Current supplied to the drive motor.
menu: MACHINE TEST > AUTO STOP TEST
Test parameters;
• Status - Exerciser detected on or off the running belt.
• Step Count - Average # of footplants. Footplant averaging delay
reset with each speed change.
.
menu: MACHINE TEST > INCLINE TEST
Test parameters;
• A/D - lift motor incline position potentiometer A/D number.
LED Console Standard Service Menus
TEST DESCRIPTION
4 Standard Service Menus
Page 21