set the correct gap. If the gap or alignment are off adjust the running deck until the mag-
net and auto housing are properly aligned, see
page
49.
7. Reconnect the Auto Stop Cable to the Auto Stop Sensor Assembly.
8. Replace front hood and side step cover.
9. Connect power cord and Switch the input power ON.
10. Verify the Auto Stop function by doing the Auto Stop diagnostics test, see .
11. Verify treadmill operation per "" and return to service.
.See Also
"Replacement Procedures" on page 48
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Auto Stop Sensor Replacement
"Auto Stop Magnet Replacement" on
Page 52