Procedure 6.8 - Replacing The Input Module - Precor C932i Service Manual

Procedure 6.8 - Replacing the Input Module

1. Set the treadmill circuit breaker in the "off" position and unplug the treadmill's line cord from
the A.C. outlet.
2. Remove the treadmill's hood.
3. Remove the two screws that fasten the A.C. input panel to the frame. See Diagram 6.4.
4. Lift the A.C. input panel from the frame and rotate it to expose the A.C. line cord clamp
screws and input module screws. See Diagram 6.5.
5. Remove the hardware that retains the A.C. line cord clamp and remove the clamp.
6. Disconnect the A.C. line cord from the input module.
7. Disconnect the wiring from the input module (1 blue wire, 1 brown wire and 1 green/yellow
wire).
8. Remove the hardware that retains the input module and remove the input module.
9. Set the input module in its mounting position with the side with two terminals facing the
circuit breaker.
10. Connect the blue wire removed in step 5 to terminal "N", the brown wire to terminal "L" and
the green/yellow wire to terminal "E" of the input module.
11. Insert the A.C. line cord firmly into the input module. Set the A.C. line cord clamp in its
mounting position and fasten it with the hardware removed in step 5.
12. Set the input panel in its mounting position and fasten it with the hardware removed in step
3.
13. Check treadmill operation per Section 3.
20077-112
C932i, C946i Treadmill
Page 45