Precor GEN06 Series Service Manual page 94

6. Slide the new Take-Up roller through the running belt and slide into position. Evenly
hand tighten the left and right Take-Up roller mounting bolts a few turns only.
7. Tension the running belt to specification and verify tracking, see
and Tracking Adjustment" on page
8. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take-Up roller shaft, see
9. Replace the end cap (see
10. Replace the hood cover.
11. Verify treadmill operation (see
.See Also
"Replacement Procedures" on page 48
"Running Belt Tension and Tracking Adjustment" on page 45
"Running Belt and Deck Replacement" on page 81
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
45.
"End Cap & Belt Guard Cover Replacement" on page
"End Cap & Belt Guard Cover Replacement" on page
Operation Verification) and return to service.
6 Replacement Procedures
Take-Up roller Replacement
"Running Belt Tension
66.
66).
Page 87