E-Stop Not Communicating - Precor GEN06 Series Service Manual

E-Stop Not Communicating

The error 37 is generated by the upper
gets into an E-Stop state and the upper PCA in the console did not know about it. The system
uses pin 8 of the data cable to communicate E-Stop states between the console and the lower
control module.
Related Error Codes
E-Stop error code: 37.
Refer to the Error Code Troubleshooting Guide
information.
Procedure
Refer to the Error Code Troubleshooting Guide
information.
See Also
"System Troubleshooting Procedures" on page 99
1
Printed circuit assembly, generally referred to as either an upper PCA or lower PCA.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
PCA in the console when the lower control module
for error code description and troubleshooting
for error code description and troubleshooting
7 Troubleshooting
System Troubleshooting Procedures
Page 111