Replace The Engine Air Filter Element - Duetz Models - Genie GS-3384 Service Manual

January 2013
Check the Down Limit Switch Height
1 Turn the key switch to platform controls. Start
the engine.
2 Raise the platform approximately 15 ft / 4.6 m.
3 Lower the platform until the down limit switch
activates and the platform stops lowering.
4 Push in the red Emergency Stop button to the
off position.
5 Measure the distance between the working
surface and the platform deck.
GS-3384
GS-3390
GS-4390
GS-5390
Part No. 84793
C-3
Replace the Engine Air Filter
Element - Deutz Models
Note: Engine specifications require that this
procedure be performed every 500 hours or semi-
annually, whichever comes first. Perform this
procedure more often if dusty conditions exist.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
95 to 107 inches
life. Failure to perform this procedure can lead to
2.4 to 2.7 m
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
106 to 118 inches
2.7 to 3.0 m
1 Release the latches on the engine tray and fully
118 to 130 inches
3.0 to 3.3 m
2 Insert a 6 inch / 15 cm screwdriver or rod into
3 Remove the air intake hose from the engine
4 Disconnect the retaining clamp from the air
5 Remove the filter element.
6 Clean the inside of the canister and the gasket
7 Install the new filter element.
8 Install the air filter canister end cap and connect
Note: Be sure the air cleaner intake hose is
inserted in the hole in the front of the engine slide
out tray.
GS-84 • GS-90
Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
slide the engine tray out.
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
slide out tray.
cleaner canister.
with a damp cloth.
the end cap retaining clamp.
3 - 31