6.
COMMISSIONING
Safety precautions
6.1
The following residual risks are present during the
commissioning of the machine and cannot be elimi-
nated:
Electrical hazard:
When using the electrical appliance, several safety
standards must be observed:
• do not touch the appliance with wet or damp hands
or feet;
• do not use the appliance if barefooted;
• do not pull the power cord to disconnect the appli-
ance.
Danger of high temperature:
Some parts of the machine can reach high tempera-
tures:
• avoid contact with the dispensing group and water
spouts;
• do not expose your hands or other body parts to the
coffee, steam, or hot water spouts.
Preparing the filter holder
6.2
6.2.1 Filter holder
• In the housing of the filter holder (4) place the spring
to stop the filter (2).
• place the single cup (1) or double cup filter (2) push-
ing it with force into the filter holder.
6.2.2 Spouts
Complete the filter holder by mounting the single
cup (5) or double cup spout (6).
2
4
6
Properly connect the single filter with the single spout and the
double filter with the double spout.
24
76
of
1
3
5
Coffee grinding
6.3
To adjust the coarseness of the ground coffee, use
the appropriate regulator located on the hopper of the
grinder-dispenser.
Autosteamer
6.4
6.4.1 Temperature adjustment
To program the temperature of the milk to be heated
see par. "8.4 Services tuning" on page 31 .
However, we recommend not to exceed 60° C.
6.4.2 Milk foaming adjustment
For more or less foam, adjust the special regulator (X).
Turning it clockwise will decrease the consistency,
while turning it counter-clockwise will increase it.
X
TECHNICIANS manual