Panasonic UF-E1 Service Manual page 94

UF-E1
Code Mode
544 XMT ECM
550 XMT
552 RCV
554 XMT ECM
555 XMT ECM
570 RCV
571 XMT
572 XMT
573 RCV
623 XMT
630 XMT or
RCV
(Polling)
631 XMT
634 XMT
638 XMT
712 Internet
XMT
714 XMT
RCV
716 Internet
XMT/RCV
717 Internet
XMT/RCV
720 Internet
XMT/RCV
721 Internet
XMT/RCV
725 Internet
XMT/RCV
726 Internet
XMT/RCV
Phase Description of Problem
D Stopped Transmission after EOR Trans-
mission.
B No response received within 45 sec
after sending training.
C No response received within 12 sec
after sending RNR.
D Transmitted ERR after receiving EOR.
D Transmitted PIN after receiving EOR.
B Password or machine code did not
match duringremotediagnosticcommuni-
cation.
B Remote unit did not have the remote
diagnostic function.
C There was no response while machine
transmitted the data during remote diag-
nostic communication.
C Unit could not receive the data from
remote unit duringremotediagnostic-
communication.
A No document was in the ADF. (Built-in
dialer engaged)
B Redial count over.
A "STOP" button was pressed during Auto
Dialing.
Redial count over with no response.
Power turned off with applicable data in
memory or during communication.
Incorrect destination email address.
Email communication error.
Cannot logon to the designated DNS
Server, SMTP Server or POP Server.
Incomplete SMTP Protocol transmis-
sion.
Unable to connect with the POP Server. Incorrect POP Server Name is set.
Unable to login to the POP Server.
DNS Server connection timed out.
Received an error response from the
DNS Server.
Information Code
Line is faulty.
NCU PCB abnormal.
Line quality is poor. Try it again.
Ask transmitter to send again and
receive it into memory. (Use Memory
Reception)
Faulty line.
Faulty line and Operator Call requested
by RX side.
Remote unit is defective.
Remote unit is defective.
Operator removed the document from
the ADF after dialing was completed.
Document is not set properly in the ADF.
No dial tone detected.
Second dial tone is not detected. (coun-
try dependent) Busy tone is detected.
(country dependent) T1 timer (35±5 sec)
elapsed without a signal from the
receiver.
Power switched off. Power failure
occurred.
Check the registered email address.
Try to connect again.
Incorrect DNS Server IP Address.
Incorrect SMTP or POP Server Name.
Mail Server's hard disk may be full.
Mail Server is defective.
POP Server is down.
Incorrect POP User Name or Password
is set.
Incorrect DNS Server IP address is set.
DNS Server is down.
Check the DNS Server IP address.
Incorrect POP Server Name is set.
Incorrect SMTP Server Name is set.
90
Cause