8. To remove the drive belt, simply detach the belt from the bottom of the carriage assembly (see Figure
6.12.14).
Figure 6.12.13 Clear plastic flex clamp that secures the circuit to the chassis
Figure 6.12.14 Bottom of print bar showing belt attachment to the carriage
9. To remove and replace the drive belt gear and flange assembly, simply push the gear flange away from
the gear shaft axle allowing the flange to unsnap and lift off (see Figure 6.12.15). To remove the gear,
pull it straight out from the chassis. To replace the belt gear and flange, follow this procedure in
reverse order.
Flex clamp
Belt pulled up to
rem ove from carriage
Teeth that hold
carriage to b elt
197
UF-E1