Panasonic UF-E1 Service Manual page 154

UF-E1
6.3.4 Built in TAM
The machine is equipped with built in TAM. Flash memory is adapted to record messages so even when a
power failure has occurred, the messages will not be lost.
1. TAM OGM (Outgoing Message) Recording
A TAM OGM can be recorded for Max. 30 seconds.
Note:
The TAM OGM is set for 30 seconds, and FIRST OGM and LAST OGM in FAX/TEL Automatic
Switching mode are set for 4 seconds and 8 seconds respectively.
2. Message Recording
It is possible to record up to 99 ICMs (Incoming Messages) or a maximum of 15 minutes in total. You
can select recording time of 30 seconds, 60 seconds, 90 seconds or 180 seconds for the ICMs.
3. Automatic Voice Message Transfer
You can program the machine to transfer a ICM (Incoming Massage) to the specified station. After a
new message is recorded, the machine will automatically call the preprogrammed telephone number.
You can listen to the message at the called telephone set by entering the Remote Control Password
using the keypad on the telephone.
Note:
The code must be entered using DTMF (Dual Tone Multi-Frequency.)
4. Time Stamp
ICM recorded time (Day / Hour / Minute) will be displayed on the LCD when it is playing back.
5. Memo / 2-Way Recording
Two types of memo recording are available and you can play back the memo from the control panel
features. Recording time for each memo will vary depending on the memory available. Each memo is
counted as an ICM.
Memo Message: A message can be recorded from the built-in microphone.
2-Way Recording Memo: Conversation over the telephone can be recorded for a later reference.
150