Panasonic UF-E1 Service Manual page 153

6.3.3 Message Transfer
1. You can program the machine to transfer a ICM (Incoming Message) to the specified station. After a
new message is recorded, the machine will automatically call the preprogrammed telephone number.
You can listen to the message at the called telephone set by entering the password using the keypad
on the telephone.
Note:
The code must be entered using DTMF (Dual Tone Multi-Frequency).
This procedure is illustrated in the diagram below.
2. Basic Procedure
Remote
station
[Step 1]
[Step 2]
UF-E1
Call
Message 1
Recording
Message 1
Pre-programmed station
Call
Beep ... Beep
Remote Control procedure
Message 1
149
After hearing a repeated
beep tone over the phone
enter the Remote Password
to playback the ICM.
UF-E1