Screed Program End Day - Viessmann VITOTRONIC 200 Service Instructions Manual

7379 Screed program end day

After the temperature/time profile has been selected
with "Time program for screed drying 7303" screed
drying starts immediately.
Parameter "Screed program end day 7379" can be
used to set the position of the last day of the screed
drying program within the temperature/time profile.
Note
"Heat pump for drying a building 7300" must be set
to "1" in order for the heat pump to be switched on for
screed drying.
Example:
At setting "25", the screed drying ends on the 25th day
of the temperature/time profile: See fig. 60.
If "Screed program start day 7378" is set to "0",
screed drying will only last for 26 days instead of
31 days.
A
50
40
30
20
10
1 5 10 15
Fig. 60
Set flow temperature
A
Days
B
Last day of the screed drying program: "Screed
C
program end day 7379" = "25"
!
C
20 25 30
B
Parameter group Internal hydraulics
The setting value is the last day of the screed drying
program.
233