Table of Contents
Advertisement
Default Settings and Protocol-dependent Functions
E.5 Default Display
[grundbild6zei-ohne-u-ohne-erw-mw-20070116, 1, en_US]
Figure E-3
[grundbild6zei-ohne-u-und-erw-mw-20070116, 1, en_US]
Figure E-4
[grundbild-cu-110413, 1, en_US]
Figure E-5
[grundbild-lwl-110413, 1, en_US]
Figure E-6
Spontaneous Fault Display
After a fault has occurred, the most important fault data are automatically displayed after general device
pickup in the order shown in the picture below.
[anzeige-spontanmeldungen-im-display-des-geraetes-260602-kn, 1, en_US]
Figure E-7
330
Default display of the 7SD80 for models without V and extended measured values
Default display of the 7SD80 for models without V with extended measured values
Default display of the device with Cu protection interface
Default display of the device with fiber-optic protection interface
Representation of spontaneous messages on the device display
SIPROTEC 4, 7SD80, Manual
E50417-G1100-C474-A2, Edition 02.2018
Advertisement
Table of Contents
