Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
Left Oven Thermostat–VDSC548T
To access left oven thermostat:
1. Remove landing ledge (see Landing Ledge–
VDSC548, Steps 1-3, page 90).
2. Remove left oven thermostat securing screws
and disconnect wires.
Screw
3. Repair/replace left oven thermostat.
4. Reverse procedure to reinstall.
© 2011 Viking Preferred Service
WARNING
Connector
Left Oven Function Selector–VDSC548T
To access left oven function selector:
1. Remove landing ledge (see Landing Ledge–
VDSC548, Steps 1-3, page 90).
2. Remove left oven function selector securing
screws and disconnect wires.
Screw
3. Repair/replace left oven function selector.
4. Reverse procedure to reinstall.
Connector
92