Oven Function Selector Removal; Oven Thermostat Removal; Indicator Light Removal; Oven Light Switch Removal - Viking DSCD130 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Function Selector Removal

Condition Requirements:
Control Components Accessed
1. Disconnect connector from the oven function
selector.
2. Remove screws and support panel from the control
panel assembly.
3. Remove screws and oven function selector from
support panel.
4. Reverse procedure for installation.

Oven Thermostat Removal

Condition Requirements:
Control Components Accessed
1. Disconnect connector from the oven thermostat.
2. Remove screws and support panel from the control
panel assembly.
3. Remove screws and thermostat from support panel.
4. Reverse procedure for installation.
28

Indicator Light Removal

Condition Requirements:
Control Components Accessed
1. Hold the blue lens and slide off the indicator light.
The indicator light will only slide in one direction.
2. Disconnect connectors from the indicator light.
3. Reverse procedure for installation.

Oven Light Switch Removal

Condition Requirements:
Control Components Accessed
1. Mark and disconnect connectors from light switch.
2. Remove screws and oven light switch from control
panel.
3. Reverse procedure for installation.

Door Switch Removal

Condition Requirements:
Control Components Accessed
1. Remove screws and door switch from range.
2. Mark and disconnect connectors from door switch.
3. Reverse procedure for installation.
©2010 Viking Preferred Service