Griddle-Vdsc536T-4G, Vdsc548T-6G; Vdsc536T-4Gq; 2011 Viking Preferred Service - Viking VDSC548T Series Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
Griddle–VDSC536T-4G, VDSC548T-6G,
VDSC548T-4GQ
The 15,000 BTU griddle is constructed of machined
steel with a blanchard finish and is uniquely
designed to offer excellent cooking performance
as well as easy cleanup. The griddle is equipped
with an electronic thermostat to maintain an even
temperature across the griddle once the desired
temperature has been set.
To remove the griddle assembly:
1. Lift the grease trough up and out.
2. Remove griddle.
Grease Trough
© 2011 Viking Preferred Service
WARNING
3. Remove securing screws, burner and bracket.
Griddle
Note: If RTD thermostat probe also needs
replacing, remove securing screws.
4. Disconnect igniter wire. Remove securing
screws and igniter.
Burner
5. Repair or replace.
6. Reverse procedure to reinstall.
Burner
Screw
Screw
Bracket
Screw
Screw
Screw
RTD Sensor
Probe
Igniter Wire
94