Oven Function Selector Removal; Oven Thermostat Removal; Indicator Light Removal; Oven Light Switch Removal - Viking RDSCE2305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Function Selector Removal

1. Access control components (see Control
Components Accessed).
2. Disconnect connector from the oven function
selector.
3. Remove screws, bezel, and oven function
selector from control panel.
4. Reverse procedure for installation.

Oven Thermostat Removal

1. Access control components (see Control
Components Accessed).
2. Disconnect connector from the oven thermostat.
3. Remove screws, bezel, and thermostat from
control panel.
4. Reverse procedure for installation.

Indicator Light Removal

1. Access control components (see Control
Components Accessed).
2. Disconnect connectors from the indicator light.
3. Press both tabs in and push indicator light out
from control panel.
©2012 Viking Preferred Service
! WARNING
4. Reverse procedure for installation.

Oven Light Switch Removal

1. Access control components (see Control
Components Accessed).
2. Mark and disconnect connectors from light
switch.
3. Remove screws and oven light switch from
control panel.
4. Reverse procedure for installation.

Door Switch Removal

1. Access control components (see Control
Components Accessed).
2. Remove screws and door switch from range.
3. Mark and disconnect connectors from door
switch.
4. Reverse procedure for installation.
Disassembly
39