Convection Fan Assembly; Convection Fan Cover; Convection Fan - Viking VDSC548T Series Service Manual
Electronic control dual fuel range
Hide thumbs
Also See for VDSC548T Series:
- Specification sheet (8 pages) ,
- Manual (48 pages) ,
- Use & care manual (36 pages)
Table of Contents
Advertisement
Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Convection Fan Assembly
The convection fan assembly incorporates a heating
element and a two-directional fan to move air
through the cavity ensuring even heat distribution.
Convection Fan Cover
To access Convection Fan Cover:
1.
Remove left rack support (see Rack Support
section, page 108).
2.
Remove screws and fan cover from oven
cavity.
Screw
3.
Reverse procedure for installation.
© 2011 Viking Preferred Service
Screws
Fan Cover
WARNING
Convection Fan
To access Convection Fan:
1.
Remove convection fan cover (see Convection
Fan Cover section at left).
2.
Remove screws and set convection fan
assembly on oven liner.
Convection
Fan Assembly
3.
Disconnect connector and lift convection fan
assembly from oven cavity.
Convection
Fan Assembly
Note: The mounting hole pattern for the
convection fan assembly is NOT symmetrical. Line
up holes before installing.
4.
Reverse procedure for installation.
Screws
Connector
109
Advertisement
Table of Contents
