Main Top Access - Viking VDSC548T Series Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.

Main Top Access

To access the main top:
1. Remove grates, caps, burner heads, and slide
unit out to access rear.
2. Remove 1/8" hex head screws securing burner
base to orifice holder.
Screws
Insert DSCN0074
3. Lift burner head off main top, mark igniter
wires, and disconnect from igniter.
Burner Head
Igniter
Igniter Wire
© 2011 Viking Preferred Service
WARNING
4. Remove 5/16" screws securing back guard.
5/16" Screws
5. Lift back guard up and out.
6. Remove Phillips head screws in rear securing
the left and right side trims.
Note: VDSC530T shown.
Back Guard
Screw
95