Diagnostics; Error Codes-30" Oven; Diagnostics Error Codes–30" Oven - Viking VDSC548T Series Service Manual

Diagnostics

Error Codes–30" Oven
When an error occurs, the control does the following:
SET HR MIN
88:88 MIN/SEC
AM
PM
STOP TIMER NO PROBE
COOK TIME ON DELAY
To clear the error code, press the "OFF" or "CLEAR/SETTINGS" button. The beeping will stop, error code
goes away, and normal display is shown again. A restart may be attempted, however if the error condition has
not been corrected, the error will flash again.
Error Display Detection
Door Latch Unit in clean mode and door takes greater than one minute to lock
RTD Prob RTD open or shorted
Cooling Cooling fan speed input indicates the fan is not running
Meat Probe Meat probe shorted or operation inconsistent with expected operation
No Probe Meat probe input open
Model Header No model header on EOC4 or incorrect model header for VDSC
Door The door is open during CLEAN (either the door latch has failed, the door sensor has failed or the
user has opened the door immediately after selecting CLEAN before the latch can engage)
Comm Loose communication link between EOC4 & VDSC
Key Short Key press input seen for over 30 seconds
Keyboard Internal disconnection sensed between the VDSC-tactile key PCB and the VDSC-display PCB
(these are two separate boards connected by a cable).
© 2011 Viking Preferred Service
CLOCK/
PROBE
TIMER
COOK
TIME
STOP
TIME
OVEN
FUNC
ERROR000
OVEN
TEMP
888°8
OFF
CLEAR/
SETTINGS
39