Selecting Eoc Test - Viking VDSC548T Series Service Manual

Service Diagnostics and Procedures
Diagnostics and Testing

Selecting EOC Test

1. Enter the Diagnostic mode (see Check Control Version and Entering Diagnostic Mode on page 45), toggle
the "SELECTOR KNOB" to the right to see the main menu selections in the right display:
SET HR MIN
88:88 MIN/SEC
AM
PM
STOP TIMER NO PROBE
COOK TIME ON DELAY
EOC1 is for the oven cavity on the 30"and 36"model. It is also the right oven on the 48"model.
EOC2 is for the left oven on the 48" model.
DISPLAY TEST and AMBIENT checks the temperature at the user interface.
2a. Select EOC1 and press the "SELECTOR KNOB". You should see EOC1 VER 25 (version 25 is the current
version). Toggle the "SELECTOR KNOB" to the right and you should see EOC1 Model 14 (indicating the
model header on the right board is #14).
2b. Select EOC2 (left oven) and press the "SELECTOR KNOB'. You should see EOC2 VER 25. Toggle the
selector knob to the right and you should see EOC2 Model 11 (indicating the model header
on the left board is #11).
3. To select an EOC to test, toggle the selector to the right to access the component testing parameter
screen EOC1 TEST (RH) or EOC2 TEST (LH).
SET HR MIN
88:88 MIN/SEC
AM
PM
STOP TIMER NO PROBE
COOK TIME ON DELAY
Note: Both tests are virtually the same with the exception that when testing the left oven, there are two
added test modes. One for the selector switch and the other is for the thermostat control.
Note: At any time, press the "CLEAR/SETTINGS" button to return to main EOC test or press "OFF" to exit
diagnostics.
© 2011 Viking Preferred Service
CLOCK/
PROBE
TIMER
COOK
TIME
STOP
TIME
CLOCK/
PROBE
TIMER
COOK
TIME
STOP
TIME
OVEN
FUNC
00000000
OVEN
TEMP
888°8
OFF
CLEAR/
SETTINGS
EOC1 / EOC2 / DISPLAY TEST
AMBIENT
OVEN
FUNC
00000000
OVEN
TEMP
888°8
OFF
CLEAR/
SETTINGS
EOC1 TEST / EOC2 TEST
/
/ EXIT
46