3M Versaflo TR-800 Series User Instructions page 12

To install the belt:
1. With a filter/cartridge and filter cover installed, place the motor/blower face down on a table with outlet facing away
from you.
2. Place the 4 keyholes (Fig. 8-2) of the belt onto the 4 T-bars (Fig. 8-1) on the back of the motor/blower (Fig. 8-3).
3. Push down on the belt between the top and bottom keyholes on each side using your thumbs (Fig. 8-4).
4. Slide the belt up (Fig. 8-5) until the belt snaps over the belt locking tabs on the bottom of the motor/blower (Fig. 8-6).
5. Gently tug on belt to ensure it is securely attached to the motor/blower unit.
6. Position the motor/blower. Typical use is to rest it in the small of the back. Tighten belt for a snug comfortable fit. A belt
extender is available if additional length is needed.
7. Secure excess belt length into the belt keeper. Excess belt length may be carefully trimmed if it will not be needed.
To remove the belt from the motor/blower, lift the lower, center portion of the belt over the locking edges and slide the belt down.
Fig. 8-1
Fig. 8-3
Fig. 8-5
Fig. 8-2
Fig. 8-4
Fig. 8-6
Fig. 8 – Installing belt
9