Siemens SINAMICS G110M Function Manual page 223

9. Open the SIMATIC Manager.
10.Assign the TCP/IP interface to "Intel(R) PRO/100 VE Network Connection" via
"Tools/PG/PC interface".
You have allocated your computer the IP address and the address of the subnet mask, and
defined the PC interface via which STARTER goes online with the inverter.
Make the inverter visible in the control
If you have configured the inverter using GSDML, then in STEP 7 you must generate a
reference of the inverter for STARTER. Only then can the inverter be seen in the control, and
you can access the inverter using STARTER.
The procedure is described using a CU240-2 Control Unit as example.
Procedure
Proceed as follows to create a reference of the inverter for STARTER:
1. Highlight the project in the SIMATIC manager
2. Open the "Insert single drive unit" screen form by right clicking on "Insert New
Object/SINAMICS".
3. Under the "Drive device/address" tab, set the device family, device and the firmware
version.
4. In the device version, select your inverter.
5. Set the online access.
6. Set the address.
Fieldbuses
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
Appendix
A.1 Communication with STEP7
223