Siemens SIMATIC MV500 Operating Manual page 78

Application
5.1 Program
Formatting instruction
%q<0 ... 35>
%Q<0 ... 33>
(depending on verification
standard)
%Qt
%Qs
78
Meaning
Formatting instructions with lowercase "q" represent the quality values, uppercase "Q" the
quality grades. For some verification standards, there are quality values without an assigned
grade, and there are also grades without a numerical value. Grade and value formatting
instructions not used in the active verification standard cause format errors. Quality grades
are output with one digit, quality values with four digits.
If a verification error occurs and if the decoder option "Evaluate 'Poor' evaluation as 'N_OK'"
is disabled, the letter 'E' is output instead of the quality grades and the four-digit error code
(47xx) is output instead of the quality values. You will find a description of the verification
error messages in the operating instructions in the section "Read and verification error mes-
sages".
Only for verification according to ISO/IEC 15416
With the exception of the overall quality, width, height, aspect ratio 1 to 3 and angle, all val-
ues and grades are output ten times, once per scan line. All quality formatting instructions
specified in an uninterrupted sequence are sorted according to the scan line and semicolons
are inserted between the grades (or values). A \r (carriage return) is added before and after
each scan line.
Example:
Formatting instruction: "%Q0#%Q1%Q25#%Q24"
•
Output: "Overall quality#\rSymbol contrast1;Edge determination1;\rSymbol con-
•
trast2;Edge determination2;\r[...]Symbol contrast10;Edge determination10;\r#\rScan
line1;\rScan line2;\r[...]Scan line10;\r"
ISO/IEC 29158
ISO/IEC 15415
AS9132 A
ISO/IEC 16022
Siemens DPM
ISO/IEC 15416
Quality evaluation:
1: Poor
•
2: Fair
•
3: Good
•
Verification type Verification type (exposure settings not
conforming to standards or uncalibrated
1
2
3
4
5
6
Operating Manual, 05/2019, C79000-G8976-C495-02
verification)
B
C
D
E
F
G
SIMATIC MV500