Chart Auto-Selection - Garmin G500 Pilot's Manual

Hide thumbs Also See for G500:
Table of Contents

Advertisement

1. While viewing the Chart page of the FPL page group, press the SELECT soft key
to change the airport.
2. Use the small MFD knob to change the character.
3. Use the large MFD knob to move the cursor to highlight a character.
4. Press ENT to accept the selected airport.
5.1.4.4

Chart Auto-Selection

The Chart page will automatically select a chart to display when the page is
opened.
NOTE: The chart for the destination airport or loaded approach will
automatically be selected.
• While on the ground, the nearest airport diagram will be displayed.
• If an approach is loaded in the selected GPS navigator, the chart for that
approach will be displayed. In some cases, the pilot may be prompted to
select the correct chart from a list of possible matches.
• If an approach is not loaded, the airport diagram for the destination
airport will be displayed.
• If no destination airport exists, the nearest airport diagram will be
displayed.
NOTE: Automatic chart selection only occurs when the Chart page is
opened. For example, if a new approach is loaded while the Chart page is
open, a different MFD page must be selected and the Chart page re-opened
for the new approach chart to be automatically displayed.
When the pilot has manually selected a chart to display, a different chart will
not be automatically selected until one of the following events occurs:
• The aircraft takes off or lands
• A new or different approach is loaded
1. While viewing the Chart page of the FPL page group, press the SELECT soft key
to activate chart selection.
2. Turn the large MFD knob to highlight the field to the right of the airport
identifier.
190-00601-02 Rev. J
Garmin G500/G600 Pilot's Guide
TOC
Cover
5-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

G600

Table of Contents