Synchronization - Garmin G500 Pilot's Manual

Cover TOC
1. While viewing the System Setup page of the AUX page group, press the small
MFD knob to activate the cursor. Turn the large MFD knob to highlight the
desired Temp Reference value.
2. Turn the small MFD knob to select the Temp Reference type and press ENT
3.2.1.6

Synchronization

Dual GDU 620 units when connected in the aircraft may be set up to
communicate and share information by "Crossfilling" or synchronizing
information between the two units. A single GDU 620 may be set up to
synchronize the database with a navigator.
Crossfill synchronization for CDI and Baro Corrections are selected in the
System Setup page of the Aux page group. Database Synchronization is managed
in the DB Sync function on the System Status page of the Aux page group.
1. While viewing the first page of the AUX page group, press the small MFD knob
and turn the large MFD knob to highlight "CDI," "BARO," "Databases," or
"Chart Streaming" in the "Synchronization" box in both units.
NOTE: Chart Streaming appears only when the Databases option is turned on.
2. Turn the small MFD knob to select "ON" or "OFF."
3. Press ENT.
3-32
Figure 3-43 Outside Air Temperature Selection
Figure 3-44 Dual Unit Synchronization
Garmin G500/G600 Pilot's Guide
.
190-00601-02 Rev. J