Figure 3-14 Chart Configuration Page - Garmin GTN 6 Series Maintenance Manual

Alert Settings
The GTN HTAWS alerting algorithm adapts the terrain alerting criteria based on nearby airports. The
Airport Criteria configuration options allow the user to select the minimum criteria that the airport must
meet to be considered as a nearby airport for the purpose of HTAWS alerting.
3.3.4.2 ChartView Re-Enablement (GTN 7XX Only)
NOTE
This manual only describes the necessary steps to re-enable the ChartView feature for
existing installations. For first-time ChartView enablement, refer to GTN 6XX/7XX
Part 27 AML STC Installation Manual.
NOTE
The ChartView Feature Enablement Card should be provided to the customer after service
to the GTN has been completed.
The GTN 7XX can display Jeppesen charts using the optional ChartView feature, which must be activated.
Complete the following procedure to re-enable ChartView:
1. Remove power from the GTN.
2. Remove the database data card from the data card slot.
3. Insert the ChartView Enablement Card (P/N 010-00878-40) used during initial installation.
4. Power up the GTN in Configuration mode.
5. Go to the Charts page from the GTN Options page.
6. Touch the ChartView key.
7. When prompted, touch Yes to enable ChartView. When activated, the ChartView key will be lit
green.
190-01007-B1
Rev. 4

Figure 3-14 Chart Configuration Page

GTN 6XX/7XX Part 27 AML STC Maintenance Manual
Page 3-14