Troubleshooting - MULTIQUIP GLOBUG GBX24S Operation Manual

FUSE
Starter does not perform properly.
Fuse 1 Everything works properly except for starter.
No errors indicated.
Engine is not started in cold environments (glow heater
Fuse 2 does not perform).
Glow lamp is not lit.
Fuse 3 The start failure or the glow trouble occurs sometimes.
Fuse 4 Motor winch for the mast does not perform properly.
Non-reactive after the key switch turns to ON and preheat.
Starter performs properly, but engine is not started.
Fuse 5 Fuel pump does not work (under the normal condition,
there will be the pump noise when turning the ignition key
switch to ON).
Engine is not started in cold environments (glow heater
Fuse 6 does not perform).
Glow lamp is ON.
Engine is not started.
Nothing happens even when key switch is turned.
PAL Fuse (50 A)
Actuator on lampstand does not work properly.
Lamps such as tail lamps work properly.
GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19) — PAGE 43
Table 16. Fuse Troubleshooting
REASON FOR TURNING OFF

TROUBLESHOOTING

CAUSE
Problems on the ECU or other things
related to the starter.
Problems on the ECU or the other
things related to the glow lamp.
Problems on the ECU or around it.
Problems on the motor winch on the
mast or the wirings to it.
Problems on fuel pump. fuel sensor,
fuel meter, the lampstand actuator,
panel lamp, glow lamp, alternator or
wirings to these components.
Problems on the glow heater, wirings
to the glow heater or around it.
Problems related to DC12V (battery
connection) or wirings to these
components.