MULTIQUIP GLOBUG GBX24S Operation Manual page 21

Refer to Figure 6 for the location of the components listed
below.
1. Lamp— 600 Watt LED lamp with industrial grade,
impact and weather resistant shell enclosure. Lamp
Arm — Holds the lamp and permits multiple directional
adjustments.
2. Lamp Arm — Holds the lamp and permits multiple
directional adjustments.
3. Main Lamp Power Cable — Connects the lamp
assemblies to the power output of the generator.
4. Mast Handle — Aids the operator in rotating the mast
to the desired direction. Mast lock must be disengaged
to rotate the mast.
5. Lifting Eye — Use this center of gravity lifting point
when required to transport the unit via a supportive
chain or strap. NEVER stand underneath the GBX24S
while it is being lifted.
6. Rear Hatch — Lockable and provides immediate
access to the engine, generator, fuel tank, and 12V
battery.
7. Forklift Pockets — For the ease of light tower
transportation via a forklift.
8. Locking Pin — These pins must be securely in place
once the jackstands are positioned to ensure the overall
security of the jackstands and outrigger sections.
9. Outriggers — Should always be deployed and locked
in place during operation.
10. Jackstand — Two jackstands and outrigger assemblies
are provided to properly secure the unit including on
uneven surfaces and to withstand windy operating
conditions.
11. Tires — The GBX24S utilizes two ST175/80 R-13 5-lug
pneumatic tires. Replace with only recommended type
tire. NEVER allow the rear tires to go flat.
GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19) — PAGE 21
COMPONENTS (GBX24S)
12. Safety Chain — A safety chain is provided to be
included in the proper process of preparing the light
tower for towing.
13. Ground Terminal — Connects to ground.
14. Control Panel — The singular control station to start/
stop the engine, monitor the engine safeguards, view
the hour meter, control the lamp dimmer, adjust the
lamp stand position, and access the main circuit
breakers.
15. Winch Handle — Opposing operating handles that
controls the mast sections in travel.
16. Mast Winch — A self-locking, mechanical hoist that
controls the mast sections to effectively raise and
lower the entire assembly. Always be on the lookout
for overhead obstructions. Keep immediate area free
of bystanders and debris when raising the mast.
17. Mast — 5-stage telescopic mast assembly that is
mechanically raised to a maximum height of 23 feet,
and pivots 359 degrees.
18. Actuator — Permits the adjustment of the lamp stand
via the control panel.
19. Lamp Stand — Secures the 4 LED lamps and is
electrically adjustable via the control panel.