Storage - MULTIQUIP GLOBUG GBX24S Operation Manual

PREPARATION FOR STORAGE
1. Place the lamp switch on the control panel to the off
position to turn the lamps off.
2. Turn the ignition switch to the OFF position to shut
down the engine.
3. Unscrew the mast locking knob to release the mast
for rotation.
4. Rotate the mast to the original stow position.
5. Tighten the mast locking knob to secure the mast.
6. Turn the actuator switch to the left and hold until the
lampstand is completely lowered.
7. Turn the winch handle counterclockwise until the mast
is completely lowered.
BALLOON STORAGE
1. Unzip the cover pocket at the top of the balloon. Take
out the cover and fold the balloon with it (Figure 23).
Figure 23. Unzipping Balloon Cover
2. Cover the balloon and lampstand. Zip up the cover and
fasten the 4 buckles (Figure 24).
BUCKLE
Figure 24. Zipping Balloon Cover
GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19) — PAGE 29
BALLOON
POCKET
BALLOON
COVER
ZIPPER
BUCKLE
LIGHT TOWER STORAGE
1. Wipe dirt or foreign matter that may have accumulated
on the light tower during operation. Use a mild detergent
to clean the unit. DO NOT spray the engine with water.
2. Avoid storing the light tower in areas that can be
exposed to rain, harsh elements, and high humidity.
3. Place the light tower in a clean dry location away from
dirt and debris.

STORAGE