MULTIQUIP GLOBUG GBX24S Operation Manual page 26

3. The lampstand will begin to rise (Figure 16). When
the lampstand is in the desired position, release the
actuator switch. The actuator switch will return to the
center position automatically and lampstand will stop
rising.
GBX24S
GBX24B
Figure 16. Raising and Lowering Lampstand
4. Turn the actuator switch clockwise to tilt down the
lamp stand. When the lamp stand is in the desired
position, release the actuator switch. The actuator
switch will return to the center position automatically
and lampstand will stop lowering.
EXTENDING THE MAST
DANGER
ALWAYS make sure the area above light tower is
open and clear of overhead power lines and other
obstructions. The tower extends in excess of 23 ft.
(7 meters). Contact with overhead power lines or other
obstructions could result in equipment damage, serious
injury or death!
CAUTION
Always make sure the trailer in on level ground with the
outriggers fully extended before extending the mast.
The outriggers must remain fully extended while the
mast is extended.
PAGE 26 —GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19)
1. Unlock the shackle (Figure 17).
UNLOCK
Figure 17. Unlocking the Shackle
CAUTION
NEVER raise the mast without releasing the shackle.
Equipment might get damaged.
2. Turn the mast winch clockwise to raise the mast
and observe tha the mast begins to extend upwards
(Figure 18).
Up
WINCH HANDLE
Figure 18. Extending the Mast
3. Continue turning the mast winch clockwise until the
desired height has been reached.
4. Release the mast winch. The winch is a self-locking
type and the tension on the cable will keep the mast
in place.
SETUP
LOCK
Down