Figure 12: Connect External Devices and IOC Cables
Connect to a Network for Out-of-Band Management
1.
2.
Connect a Management Console
1.
2.
Connect the IOC Cables
1.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
ALA RM
RE CO NS
OLE
SC B FRO
0
NT
0
PW R
HA RE AR
1
FAN
1
Plug one end of the RJ-45 Ethernet cable into the
Switch Fabric Board (SFB).
Plug the other end of the cable into the network device.
Plug the RJ-45 end of the serial cable into the
Fabric Board (SFB).
Plug the female DB-9 end into the device's serial port.
Have ready a length of the type of cable used by the IOC. For cable specifications,
see the SRX 3400 Services Gateway Hardware Guide.
If you are connecting a fiber IOC cable, the connector port may be covered by
a rubber safety cap. If it is, remove the cap.
Step 4: Connect the External Devices and IOC Cables
RE ETHERNET 0
RE CONSOLE 0
Step 4: Connect the External Devices and IOC Cables
port on the
port on the Switch
13