Step 6: Connect Power Cables; Connect Power To An Ac-Powered Services Gateway - Juniper SRX5600 Getting Started Manual
Services gateway
Hide thumbs
Also See for SRX5600:
- Hardware manual (483 pages) ,
- Installation and initial configuration manual (205 pages) ,
- Manual (34 pages)
Table of Contents
Advertisement
SRX5600 Services Gateway Getting Started Guide
Step 6: Connect Power Cables
Connect Power to an AC-Powered Services Gateway
16
Proceed to
"Step 6: Connect Power Cables" on page
Depending on its configuration, the services gateway uses either AC or DC power supplies.
Perform the appropriate procedures for each power supply in the services gateway.
Connect Power to an AC-Powered Services Gateway on page 16
Connect Power to a DC-Powered Services Gateway on page 17
This procedure addresses connecting power to services gateways equipped with either
standard-capacity or high-capacity AC power supplies.
WARNING:
To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, you must properly ground the
services gateway chassis before connecting power. See
the Grounding Cable" on page 13
NOTE:
The services gateway must be running Junos OS Release 12.1X44-D10
or later in order to use high-capacity AC or DC power supplies.
NOTE:
The device is not shipped with AC power cords. Make sure to order or
obtain AC power cords with a plug appropriate for your geographical location.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see the SRX5600 Services Gateway Hardware Documentation at
www.juniper.net/techpubs/
Locate the power cords you will use to connect the device to AC power. See the
2.
SRX5600 Services Gateway Hardware Documentation at
for specifications.
For each power supply:
3.
Move the power switch on the power supply faceplate to the
a.
Insert the appliance coupler end of the power cord into the appliance inlet on the
b.
power supply
(Figure 10 on page
Insert the power cord plug into an external AC power source receptacle.
c.
16.
for instructions.
.
17).
Copyright © 2013, Juniper Networks, Inc.
"Step 4: Connect
www.juniper.net/techpubs/
position (
).
OFF
O
Advertisement
Table of Contents
